CONFIGURATIONS

Elastimold Molded Switchgear allows users to mix & match components as needed for each circuit application or to standardize on basic circuits that provide the desired flexibility and reliability. The various components may be stocked and assembled as needed to meet the specific requirements. Future taps can be dead end capped until needed. Switch and fuse taps are easily installed in the field.

MMS Molded Switchgear is so flexible and can be arranged in so many configurations, that it is typically shipped unassembled in kit form.

Individual components may be ordered directly from Table 1 and Table 2 on page 4 or by Line Diagram following the steps in the worksheet.

Table 1 - Molded Switchgear Components

Notes:

*6-200 Amps available at 5 kV

N1. Includes an insulating plug(BIP) for connection to a Multi-point junction.

N2. Requires 200A Bushing Insert & Elbow for tab connection.

N3. Requires 600A Elbow for tap connection.

N4. To complete catalog number, replace Z with fuse amperage code from Table F1 on page 7.

N5. To complete catalog number, replace Z with fuse amperage code from table F2 on page 7.

N6. To Complete catalog number, replace WX per instruction in Table F3 on page 7.

N7. To complete catalog number, replace Z with fuse amperage code from Table F3 on page 7.

Table 2 - Multi-point Junction Catalog Number Construction

Using diagram to the right, Construct a catalog number describing the required junction. Choose number of points. Choose interface for each position Referring to Table 1, "Junction Bushing" column, specify either "2" or "6" for selected components. Specify "2" for additional 200 A Bushing Wells. Specify "6" for additional 600A Bushings. Choose voltage class